Collapsible LoTR Narsil Sword

Description

This collapsible sword is a replica of the Aragorns broken blade from lord of the rings. 

Held together by two m3x5 screws. Slide the dowel into the pommel and the grip. Use glue to secure the two pieces together. 

On my print I used silk+ titan gray for the blade and PLA matte black for the grip. 

If you have any issues with the print please make sure you have done the following.

1. Clean your build plate with soap and use glue if bed adhesion persists.
2. Dry your filament. Stringing inside the blades will cause them to bind up when detracting

3. Make sure you properly remove all of the brim from the blades after printing or they might not fit properly.

    

Assembly: 

1. Nest all of the blades together. 

2. Slide the nested blades into the guard.

3. Slide the dowel into the grip and the pommel. Use glue to secure the two pieces together 

4. Put the grip/pommel assembly into the guard/blade assembly. Secure the two assemblies together with two m3x5 screws.